I am new on citilab cube. After completing licencing i wanted to run cube voyager demonstration model but i am unable to do that. how can i open the this window like the following-
There are two steps to accessing the demonstration model.
Have you downloaded and installed Cube yet? Depending on which license you have installed, you need to download Cube as well. If you ran setup.exe for licensing then you need to install Cube 6.1.1 (or earlier) but if you have a 16-digit activation key then you need Cube 6.4 or later:
[NOTE: license installation for 6.1.1 is before software installation whereas license activation for 6.4 is after software installation]
Now you have Cube running, you need to download the demonstration model Cubetown (packaged as an installation). You can do this from the left hand menu in Cube or you can download directly form our learning page:
(direct link: http://citilabs-website-resources.s3.amazonaws.com/release/cubetown610setup.exe)
If you need training then please see our introduction to Cube online training here:
Thank you for posting to the Cube forums, what you are looking at is the application window. When you load up Cube and open the catalog file, you want to find the application window, shown in the graphic below. When you double click on the application, shown in the image below as PT Tier A Model, you will see the application window load the item you are seeing.
If you have any other questions, please ask.